Drip irrigation line is...well...dripping

On Thu, Sep 18, 2008 at 9:45 AM, Bette wrote:

Hi! I saw your UTube video on repairs for drip lines...it was fantastic..thank you! I have another question, though..I hope this site is still active and that you can get back to me. I have a drip line leak at the site where the emitter line is plugged into the 1/2' drip line. The water is coming out pretty good around the site - but yet the feed tube line is not easy to pull out so I'm guessing that the hole isn't overly big???. I'm not sure what to do about this. There is always enough water to puddle up so it's a significant leak. Thanks for any help. bette

Thanks for writing. In my experience, this happens when the emitter is not quite seated all the way into the 1/2" tube. The little barb edge on the emitter has to go all the way into the tube in order to make a seal. I typically push the emitter in and then tug on it to make sure the barb has gone through the wall of the larger tube, basically wiggling it around to make it seal against the side of the tube.

It could be, too, that the whole is just a bit misshapen. If adjusting the emitter doesn't work, it might be easier to simply plug that existing hole and punch a new one nearby. The make little plugs to do that, although is the hole is the issue then even the plug might not work well.

I hope this helps. Give it a try and let me know.



Here is the YouTube video mentioned in this email...